Catalog Categories Part Numbers Manufacturers Search

A1185EUA

A1185EUA Manufacturer

A1185EUA Description

A1185EUA Description

A1185EUA Categories

A1185EUA Datasheet (PDF)

A1185EUA Datasheet
A1185-86

A1185EUA Price & Availability


Check A1185EUA Price & Availability at Canics

A1185EUA Features

  • Chopper Stabilization
    • Low switchpoint drift over operating temperature range
    • Low stress sensitivity
  • Field-programmable for optimized switchpoints
  • On-chip Protection
    • Supply transient protection
    • Reverse-battery protection
    • On-board Voltage Regulator
    • 3.5 V to 24 V operation

A1185EUA Description

    The A1185 and A1186 devices are ultrasensitive, two-wire, unipolar, Hall effect switches. The operate point, BOP, can be field-programmed, after final packaging of the sensor and placement into the application. This advanced feature allows the optimization of the sensor switching performance, by effectively accounting for variations caused by mounting tolerances for the device and the target magnet.

    This family of devices are produced on the Allegro MicroSystems advanced BiCMOS wafer fabrication process, which implements a patented, high-frequency, chopper-stabilization technique that achieves magnetic stability and eliminates the offsets that are inherent in single-element devices exposed to harsh application environments. Commonly found in a number of automotive applications, the A1185 and A1186 devices are utilized to sense: seat track position, seat belt buckle presence, hood/trunk latching, and shift selector position.

    Two-wire unipolar switches are particularly advantageous in price-sensitive applications, because they require one less wire than the more traditional open-collector output switches. Additionally, the system designer gains inherent diagnostics because output current normally flows in either of two narrowly-specified ranges. Any output current level outside of these two ranges is a fault condition. The A1185 and A1186 devices also features on-chip transient protection, and a Zener clamp to protect against overvoltage conditions on the supply line.

    The output current of the A1186 switches HIGH in the presence of a south polarity magnetic field of sufficient strength; and switches LOW otherwise, including when there is no significant magnetic field present. The A1185 has an inverted output current level: switching LOW in the presence of a south polarity magnetic field of sufficient strength, and HIGH otherwise.

    Also see: A1180, A1181, A1182, A1183, and A1184.

    Factory-programmed versions are also available. Refer to: A1145, and A1146.

    A1185EUA Parameters

    Products Similar to A1185EUA


     

    Keywords
    A1185EUA Data Sheet A1185EUA Spec A1185EUA Application Notes A1185EUA Distributor
    A1185EUA Circuit A1185EUA Reference A1185EUA PDF A1185EUA RoHS