CY7C4261-15ACT

CY7C4261-15ACT Description

CY7C4261-15ACT Manufacturer

CY7C4261-15ACT Datasheet (PDF)

CY7C4261-15ACT Price & Availability

CY7C4261-15ACT Features

• High-speed, low-power, first-in first-out (FIFO) memories
• 16K × 9 (CY7C4261)
• 32K × 9 (CY7C4271)
• 0.5-micron CMOS for optimum speed/power
• High-speed 100-MHz operation (10-ns read/write cycle times)
• Low power ? I_CC = 35 mA
• Fully asynchronous and simultaneous read and write operation
• Empty, Full, Half Full, and programmable Almost Empty and Almost Full status flags
• TTL-compatible
• Output Enable (/OE) pins
• Independent read and write enable pins
• Center power and ground pins for reduced noise
• Supports free-running 50% duty cycle clock inputs
• Width-Expansion Capability
• Military temp SMD Offering ? CY7C4271-15LMB
• 32-pin PLCC/LCC and 32-pin TQFP
• Pin-compatible density upgrade to CY7C42X1 family
• Pin-compatible density upgrade to IDT72201/11/21/31/41/51

CY7C4261-15ACT Description

The CY7C4261/71 are high-speed, low-power FIFO memories with clocked read and write interfaces. All are nine bits wide. The CY7C4261/71 are pin-compatible to the CY7C42X1 Synchronous FIFO family. The CY7C4261/71 can be cascaded to increase FIFO width. Programmable features include Almost Full/Almost Empty flags. These FIFOs provide solutions for a wide variety of data buffering needs, including high-speed data acquisition, multiprocessor interfaces, and communications buffering.

These FIFOs have 9-bit input and output ports that are controlled by separate clock and enable signals. The input port is controlled by a free-running clock (WCLK) and two write-enable pins (/WEN1, WEN2//LD).

When /WEN1 is LOW and WEN2//LD is HIGH, data is written into the FIFO on the rising edge of the WCLK signal. While /WEN1, WEN2//LD is held active, data is continually written into the FIFO on each WCLK cycle. The output port is controlled in a similar manner by a free-running read clock (RCLK) and two read enable pins (/REN1, /REN2). In addition, the CY7C4261/71 has an output enable pin (/OE). The read (RCLK) and write (WCLK) clocks may be tied together for single-clock operation or the two clocks may be run independently for asynchronous read/write applications. Clock frequencies up to 100 MHz are achievable. Depth expansion is possible using one enable input for system control, while the other enable is controlled by expansion logic to direct the flow of data.

CY7C4261-15ACT Parameters

Products Similar to CY7C4261-15ACT